id0918008028x1

1.Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)

2.Remove the upper column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)

3.Remove the lower column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)

4.Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL [STANDARD DEPLOYMENT CONTROL SYSTEM – MEXICO SPEC.].) (See DRIVER-SIDE AIR BAG MODULE REMOVAL [TWO-STEP DEPLOYMENT CONTROL SYSTEM – US/CANADA SPEC.].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM – MEXICO SPEC.].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM – US/CANADA SPEC.].)

5.Remove the steering wheel. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [(US)].)

6.Remove the Wiper and washer switch. (See WIPER AND WASHER SWITCH REMOVAL/INSTALLATION [(US)].)

7.Disconnect the connectors.

am3zzw00027100

8.Remove the screws.

am3zzw00027101

9.While pull out the combination light in the direction of arrow (1) shown in the figure.

am3zzw00027102

10.Remove the light switch.

11.Install in the reverse order of removal.