VIBRATION CONCERNS (ENGINE) [SKYACTIV-G (US)]
VIBRATION CONCERNS (ENGINE) [SKYACTIV-G (US)]
SM2565592
id0103s48909s6
|
Troubleshooting item |
Vibration concerns (engine) |
|
|---|---|---|
|
Description
|
• Vibration from under hood or driveline.
|
|
|
Possible cause
|
• Loose attaching bolts or worn parts
• Components malfunction such as worn parts
|
|
|
System wiring diagram
|
• Not applicable
|
|
|
Connector diagram
|
• Not applicable
|
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
VERIFY PART INSTALLATION CONDITION
• Inspect the following components for loose attaching bolts or worn parts:
• Is there any malfunction?
|
Yes
|
Readjust installation position or retighten the suspect parts.
Repair or replace the malfunctioning part according to the inspection results for other parts.
Go to repair completion verification.
|
|
No
|
Inspect the following systems:
• Wheels
• Transmission and mounts
• Driveline
• Suspension
• Engine compartment
|
||
|
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Has the malfunction symptom been eliminated?
|
Yes
|
Complete the symptom troubleshooting. (Explain contents of repair to customer)
|
|
No
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
• If the CAN communication is normal, perform the diagnosis from Step 1.
|
||
|
Repair completion verification 2
|
VERIFY IF MALFUNCTION IS CAUSED BY NOT PERFORMING PCM REPROGRAMMING
• Verify repair information and verify that there is a new calibration in the PCM.
• Is there a new calibration in the PCM?
|
Yes
|
Perform the PCM reprogramming and verify if the malfunction symptom was corrected.
• If the malfunction recurs, replace the PCM. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
|
|
No
|
Replace the PCM.
|