Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

DTC B00A0:28 [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)]

< Previous Next >

2016 – MX-5 – Restraints

DTC B00A0:28 [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)]

System malfunction location

  • Occupant classification sensor calibration setting invalid

Detection condition

WARNING:

  • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

  • Calibration set value not within valid range.

Fail-safe

Possible cause

  • Occupant classification sensor deformed or malfunction

  • Object placed on front passenger-side seat during calibration of occupant classification sensor

  • Improperly installed front passenger-side seat part at time of calibration

  • Deformed floor where attached to front passenger-side seat

  • Seat warmer is dry malfunction

  • Seat cushion is damp

  • Occupant classification sensor malfunction

  • SAS control module malfunction

System wiring diagram

Diagnostic Procedure

Step

Inspection

Action

1

PERFORM SAS CONTROL MODULE CONFIGURATION (AS-BUILT DATA USE)

Yes

Go to the next step.

No

DTC troubleshooting completed.

2

INSPECT SEAT CUSHION

  • Inspect the seat cushion.

  • Is the seat cushion damp?

Yes

Seat cushion is dry.

Perform the DTC inspection again. If the same DTC is displayed, go to the next step.

No

Go to the next step.

3

INSPECT SEAT WARMER

Yes

Go to the next step.

No

Replace the seat warmer. (See SEAT BACK TRIM REMOVAL/INSTALLATION.)(See SEAT CUSHION TRIM REMOVAL/INSTALLATION.)

4

INSPECT PASSENGER-SIDE SEAT

  • Switch the ignition to off.

  • Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

  • Remove the passenger-side seat and visually inspect for the following:

    • Seat under-bracket deformation

    • Seat frame deformation

    • Foreign objects stuck in seat

  • Are any of the parts deformed or are any foreign objects stuck in the seat?

Yes

Replace the seat warmer. (See SEAT BACK TRIM REMOVAL/INSTALLATION.)(See SEAT CUSHION TRIM REMOVAL/INSTALLATION.)

No

Go to the next step.

5

INSPECT FLOOR

  • Visually inspect the installation parts of the front passenger-side seat for the following:

    • Abnormal floor deformation

    • Installation hole of front passenger-side seat is improperly positioned

  • Is the floor normal?

Yes

Go to the next step.

No

Repair floor deformation.

6

INSPECT OCCUPANT CLASSIFICATION SENSOR

Yes

Replace the occupant classification sensor. (See OCCUPANT CLASSIFICATION SENSOR REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

No

DTC troubleshooting completed.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.