REAR BUMPER INSTALLATION
2016 – MX-5 – Body and Accessories
REAR BUMPER INSTALLATION
1. Connect the connectors.
2. Install the wiring harness clip.
3. Press the rear bumper in the direction of the arrow shown in the figure and install the rear bumper to the rear bumper bracket and the body.
4. Move the rear bumper guide in the direction of the arrow shown in the figure and insert it into the rear bumper slider guide hole.
5. Hook the rear bumper to rear bumper slider in the order show in the figure.
6. Install the screws.
7. Install the screws.
8. Install the following parts:
a. Rear bumper retainer No.1 (See REAR BUMPER RETAINER No.1 REMOVAL/INSTALLATION.)
b. Rear bumper stay (See REAR BUMPER STAY REMOVAL/INSTALLATION.)
c. Rear splash shield (See REAR SPLASH SHIELD REMOVAL/INSTALLATION.)
d. Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION.)
e. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
f. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
9. Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
10. If the rear bumper is replaced, perform the blind spot monitoring radar aiming. (with blind spot monitoring system)(See BLIND SPOT MONITORING (BSM) RADAR AIMING.)