{"id":9157,"date":"2022-03-10T20:30:45","date_gmt":"2022-03-10T20:30:45","guid":{"rendered":"https:\/\/www.hexorcism.com\/19BP\/sm2335543\/"},"modified":"2022-03-10T20:30:45","modified_gmt":"2022-03-10T20:30:45","slug":"sm2335543","status":"publish","type":"page","link":"https:\/\/www.hexorcism.com\/19BP\/sm2335543\/","title":{"rendered":"TIE ROD INSPECTION [(US)]"},"content":{"rendered":"
\n

TIE ROD INSPECTION [(US)]<\/h3>\n<\/div>\n

SM2335543<\/p>\n

<\/p>\n
\n
\n
\n

id0613008029x1<\/p>\n

\n
\n
Caution<\/div>\n<\/dd>\n
\n
\n
\u2022 Performing the following procedures could cause an open circuit in the front ABS wheel-speed sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake.<\/div>\n
\u2022 If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged. After disconnecting the steering shaft, secure the steering wheel using tape or cable to prevent it from rotating.<\/div>\n
\u2022 Do not allow the dust boot of the front stabilizer control link to touch the body, the front shock absorber and coil spring, and the hand tool. Otherwise, the dust boot of the front stabilizer control link could be damaged.<\/div>\n<\/div>\n<\/dd>\n<\/dl>\n

1.Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

\n

2.Disconnect the rubber from the bracket.<\/p>\n

\n\n\n\n
<\/td>\n\n\n\n\n
<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n
am3zzw00023157<\/div>\n<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n

3.Disconnect the front ABS wheel-speed sensor wiring harness on the steering knuckle and set it aside so that it does not interfere with the servicing.<\/p>\n

\n

4.Remove the tunnel cover. (See EXHAUST SYSTEM REMOVAL\/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))]<\/a>.) (See EXHAUST SYSTEM REMOVAL\/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))]<\/a>.)<\/p>\n

\n

5.Remove the following parts.<\/p>\n

\n

\n
(1)Front under cover No.1 (See FRONT UNDER COVER No.1 REMOVAL\/INSTALLATION<\/a>.)<\/dd>\n
<\/dd>\n<\/dl>\n
\n
(2)Front under cover No.2 (See FRONT UNDER COVER No.2 REMOVAL\/INSTALLATION<\/a>.)<\/dd>\n
<\/dd>\n<\/dl>\n

6. Disconnect the tie-rod end from the steering knuckle. (See TIE-ROD END REPLACEMENT<\/a>.)<\/p>\n

\n

7.Disconnect the front lower arm ball joint from the steering knuckle. (See FRONT LOWER ARM REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

8.Remove the fastener shown in the figure and slightly bend back the front mudguard.<\/p>\n

\n\n\n\n
<\/td>\n\n\n\n\n
<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n
am3zzw00023158<\/div>\n<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n

9.Remove the front deflector. (See DEFLECTOR REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

\n

10.Remove the front splash shield. (See SPLASH SHIELD REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

\n

11.Remove the joint cover. (See INTERMEDIATE SHAFT REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

12.Disconnect the intermediate shaft from the steering gear and linkage. (See INTERMEDIATE SHAFT REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

13.Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

14.Remove the hole cover No.1 and hole cover No.2. (See FRONT CROSSMEMBER REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

15.Remove the steering gear and linkage from the front crossmember component. (See STEERING GEAR AND LINKAGE REMOVAL\/INSTALLATION [(US)]<\/a>.)<\/p>\n

\n

16.Remove the tie rod from the steering gear and linkage. (See STEERING GEAR AND LINKAGE DISASSEMBLY [(US)]<\/a>.)<\/p>\n

\n

17.Verify that there is no damage to or twisting of the tie-rod end.<\/p>\n

\n

\n
\n
\u2022 If there is a malfunction, replace the tie rod. (See STEERING GEAR AND LINKAGE ASSEMBLY [(US)]<\/a>.)<\/div>\n<\/dd>\n<\/dl>\n

18.Inspect the tie-rod end for excessive play.<\/p>\n

\n

\n
\n
\u2022 If there is a malfunction, replace the tie rod. (See STEERING GEAR AND LINKAGE ASSEMBLY [(US)]<\/a>.)<\/div>\n<\/dd>\n<\/dl>\n

19.Swing the ball joint of the tie rod 10 times<\/span>.<\/p>\n

\n

20.Measure the tie rod swing torque using a pull scale.<\/p>\n

\n\n\n\n
<\/td>\n\n\n\n\n
<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n
am3zzw00023159<\/div>\n<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n
\n
\n
\n
Tie rod swing torque<\/div>\n<\/dd>\n<\/dl>\n
\n
\n
0.4\u20144.0 N\u00b7m {4.1\u201440 kgf\u00b7cm, 3.6\u201435 in\u00b7lbf} [pull scale reading: 2.1\u201421.1 N {0.22\u20142.11 kgf, 0.48\u20144.69 lbf}]<\/div>\n<\/dd>\n<\/dl>\n<\/div>\n
\n
\n
\u2022 If not within the standard, replace the tie rod. (See STEERING GEAR AND LINKAGE ASSEMBLY [(US)]<\/a>.)<\/div>\n<\/dd>\n<\/dl>\n<\/div>\n
<\/div>\n
<\/div>\n
<\/div>\n

<\/div>\n<\/div>\n","protected":false},"excerpt":{"rendered":"

TIE ROD INSPECTION [(US)] SM2335543 id0613008029x1 Caution \u2022 Performing the following procedures could cause an open circuit in the front ABS wheel-speed sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake. \u2022 If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts […]<\/p>\n","protected":false},"author":1,"featured_media":0,"parent":0,"menu_order":0,"comment_status":"closed","ping_status":"closed","template":"","meta":{"_monsterinsights_skip_tracking":false,"_monsterinsights_sitenote_active":false,"_monsterinsights_sitenote_note":"","_monsterinsights_sitenote_category":0,"footnotes":""},"class_list":["post-9157","page","type-page","status-publish","hentry"],"_links":{"self":[{"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/pages\/9157","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/pages"}],"about":[{"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/types\/page"}],"author":[{"embeddable":true,"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/comments?post=9157"}],"version-history":[{"count":0,"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/pages\/9157\/revisions"}],"wp:attachment":[{"href":"https:\/\/www.hexorcism.com\/19BP\/wp-json\/wp\/v2\/media?parent=9157"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}