DTC P182F:00 [PCM (SKYACTIV-G)]
DTC P182F:00 [PCM (SKYACTIV-G)]
SM2515116
id0102t4976100
Outline
|
System malfunction location |
PCM i-ACTIV AWD control system |
|---|---|
|
Detection condition
|
• PCM detects excessive load detected on i-ACTIV AWD part.
|
|
Fail-safe
|
• AWD protection condition (i-ACTIV AWD control paused)
|
|
Possible cause
|
• Detects excessive load on i-ACTIV AWD part to switch to protect the system
• PCM malfunction
|
|
System wiring diagram
|
• Not applicable
|
|
Connector diagram
|
• Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snapshot data.
|
—
|
Go to the next step.
|
|
2
|
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
• Verify related Service Bulletins, on-line repair information, or Service Information availability.
• Is any related Information available?
|
Yes
|
Perform repair or diagnosis according to the available information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
ALLOW THE VEHICLE TO COOL DOWN FOR WHILE
• Switch the ignition to off and allow vehicle to cool down.
|
—
|
Go to the next step.
|
|
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification 2
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|