id0517n1600600

Continuity Inspection

Note

• The down switch is built into the selector lever component.

1.Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)

2.Remove the following parts:

(1)Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(2)Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(3)Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

(4)Cup holder (See CUP HOLDER REMOVAL/INSTALLATION.)

(5)Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(6)Rear console (See REAR CONSOLE REMOVAL/INSTALLATION [(US)].)

(7)Rear console bracket No.1 (See REAR CONSOLE REMOVAL/INSTALLATION [(US)].)

3.Disconnect the selector lever component connector.

am3zzw00021700

4.Verify that the continuity between selector lever component terminals D and H.

am3zzw00034554

• If not as verified, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)