Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

DETERMINING SHORT BETWEEN CIRCUITS LOCATION (CAN-BUS No.8) [(US)]

DETERMINING SHORT BETWEEN CIRCUITS LOCATION (CAN-BUS No.8) [(US)]

SM2566474

id1002x1004800

Caution
• Perform the following malfunction diagnosis only when it is diagnosed with a short to ground by CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(US)].)



System Wiring Diagram
am3zzw00027527



Determination Procedure

Caution
• When disconnecting the connector, verify that there is no looseness, damage, deformation, corrosion, or poor connection of the connector terminals.
• When inspecting the connector, touch it with a paper clip or similar thin pin without directly inserting a tester probe into the terminal.
• Disconnect the negative battery cable before performing any work that requires handling of connectors.

Step

Inspection

Action
1
INSPECT BODY CONTROL MODULE (BCM) FOR SHORT BETWEEN CIRCUITS
• Switch the ignition off.
• Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Disconnect the connector 3 which has body control module (BCM) terminals 3U and 3W.
• Connect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Switch the ignition ON (engine off).
• Measure the voltage at body control module (BCM) terminals 3U and 3V (wiring harness side).
• Is the voltage at body control module (BCM) terminals 2L and 2J (wiring harness side) the same?
Yes
Go to the next step.
No
Replace the body control module (BCM) because there is a short between circuits in the body control module (BCM).
(See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)
2
INSPECT TELEMATICS COMMUNICATION UNIT FOR SHORT BETWEEN CIRCUITS
• Switch the ignition off.
• Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Disconnect the telematics communication unit connector.
• Inspect for continuity between telematics communication unit terminals 1Q and 1S (wiring harness side).
• Is there continuity?
Yes
Repair or replace the wiring harness between telematics communication unit and body control module (BCM) because the wiring harness is shorted between circuits.
No
Replace the telematics communication unit because there is a short between circuits in the telematics communication unit.
(See TELEMATICS COMMUNICATION UNIT REMOVAL/INSTALLATION.)