Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

STARTER DOES NOT WORK [ET6A-EL (US)]

STARTER DOES NOT WORK [ET6A-EL (US)]

SM2566147


id0503n21029n5

Troubleshooting item

Starter does not work

Description
• Starter does not work even when in P or N position.
Possible cause
1. Wiring harness between TCM terminal J and PCM terminal 2BD malfunction
2. Wiring harness between BCM terminal 4I and LF control unit terminal L malfunction (With advanced keyless entry system)
3. Immobilizer system operating or system malfunction
4. Engine control system malfunction
System wiring diagram
• Not applicable
Connector diagram
• Not applicable

Diagnostic procedure

Step

Inspection

Results

Action

1
INSPECT WIRING HARNESS BETWEEN TCM AND PCM
• Switch the ignition off.
• Disconnect the PCM connector and TCM connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD.
• Is there any malfunction?
Yes
Repair or replace any malfunctioning parts according to the inspection result.
No
Go to the next step.
2
INSPECT WIRING HARNESS BETWEEN TCM AND LF CONTROL UNIT
• Disconnect the LF control unit connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between BCM terminal 4I and LF control unit terminal L.
• Is there any malfunction?
Yes
Repair or replace any malfunctioning parts according to the inspection result.
No
Go to the next step.
3
INSPECT IMMOBILIZER SYSTEM AND ENGINE CONTROL SYSTEM FOR MALFUNCTION
• Perform the symptom troubleshooting “WILL NOT CRANK”. (See WILL NOT CRANK [SKYACTIV-G (US)].)
• Is there any malfunction?
Yes
Repair or replace any malfunctioning parts according to the inspection result.
No
Symptom troubleshooting is completed.