Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

DTC P18A5:00 [PCM (SKYACTIV-G)]

DTC P18A5:00 [PCM (SKYACTIV-G)]

SM2515128


id0102t4977300



Outline

System malfunction location

PCM configuration

Detection condition
• PCM detects configuration data not record
Fail-safe
• Inhibits the i-ACTIV AWD control.
Possible cause
• The coupling component value is not input to the PCM correctly.
• PCM malfunction
System wiring diagram
• Not applicable
Connector diagram
• Not applicable



Diagnostic Procedure

Step

Inspection

Results

Action

1
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snapshot data.

Note
• Recording can be facilitated using the screen capture function of the PC.
Go to the next step.
2
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
• Verify related Service Bulletins, on-line repair information, or Service Information availability.
• Is any related Information available?
Yes
Perform repair or diagnosis according to the available information.
• If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
COUPLING COMPONENT CALIBRATION DATA WRITING
• Write the coupling component calibration data. (See COUPLING COMPONENT CALIBRATION DATA WRITING.)
Go to the next step.
Repair completion verification 1
VERIFY THAT VEHICLE IS REPAIRED
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
― Switch the ignition ON (engine off)
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Is the same Pending DTC present?
Yes
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)
No
Go to the next step.
Repair completion verification 2
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
Yes
Repair the malfunctioning location according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.