DTC P0506:00 [PCM (SKYACTIV-G)]
DTC P0506:00 [PCM (SKYACTIV-G)]
SM2334531
id0102t4705000
Outline
|
System malfunction location |
IAC system RPM lower than expected |
||||
|---|---|---|---|---|---|
|
Detection condition
|
• The actual idle speed is lower than expected by 100 rpm for 14 s, when the brake pedal is depressed (brake switch is on).
|
||||
|
Fail-safe
|
• Not applicable
|
||||
|
Possible cause
|
• A/C magnetic clutch malfunction
• Drive-by-wire control system malfunction
• Malfunction in injection amount measurement system (refer to DTC P0101:00)
• Purge solenoid valve malfunction
• Air cleaner element restricted
• Throttle body passage blockage
• Engine malfunction
• Generator control circuit malfunction
• PCM malfunction
|
||||
|
System wiring diagram
|
• Not applicable
|
||||
|
Connector diagram
|
• Not applicable
|
||||
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA
• Is the DTC P0506:00 on freeze frame data?
|
Yes
|
Go to the next step.
|
|
No
|
Go to the troubleshooting procedure for DTC on freeze frame data.
|
||
|
2
|
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snapshot data.
|
—
|
Go to the next step.
|
|
3
|
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
• Verify related Service Bulletins, on-line repair information, or Service Information availability.
• Is any related Information available?
|
Yes
|
Perform repair or diagnosis according to the available information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT FOR OTHER RELATED DTCs
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
Go to the next step.
|
||
|
5
|
INSPECT A/C MAGNETIC CLUTCH OPERATION
• Turn the A/C switch off.
• Is the magnetic clutch still on?
|
Yes
|
Perform the symptom troubleshooting “A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY”.
|
|
No
|
Go to the next step.
|
||
|
6
|
INSPECT DRIVE-BY-WIRE CONTROL SYSTEM MALFUNCTION
• Perform the Drive-by-wire Control System Inspection. (See ENGINE CONTROL SYSTEM OPERATION INSPECTION [SKYACTIV-G (US)].)
• Is there any malfunction?
|
Yes
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
7
|
INSPECT PURGE SOLENOID VALVE
• Perform the Purge Control System Inspection. (See PURGE SOLENOID VALVE INSPECTION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See PURGE SOLENOID VALVE INSPECTION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
• Is there any malfunction?
|
Yes
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
8
|
INSPECT AIR CLEANER ELEMENT FOR MALFUNCTION
• Remove the air cleaner element with the engine is running. (See AIR CLEANER ELEMENT REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See AIR CLEANER ELEMENT REMOVAL/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
• Does the engine speed increase?
|
Yes
|
Clean or replace the air cleaner element and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
9
|
INSPECT THROTTLE BODY PASSAGE
• Visually inspect the throttle body passage.
• Is the throttle body passage dirty and/or restricted?
|
Yes
|
Clean or replace the throttle body passage and perform the repair completion verification.
|
|
No
|
Go to the next step.
|
||
|
10
|
INSPECT ENGINE COMPRESSION
• Inspect the engine compression. (See COMPRESSION INSPECTION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See COMPRESSION INSPECTION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
• Are compression pressures within specification?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
|
11
|
INSPECT GENERATOR CONTROL CIRCUIT FOR SHORT TO POWER SUPPLY
• Apply the electrical load (such as blower fan, rear window defogger, or headlight).
• Does the engine speed increase?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
|
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
|
|
No
|
Go to the next step.
|
||
|
Repair completion verification 2
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|