Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

INITIAL LEARNING [ET6A-EL (US)]

INITIAL LEARNING [ET6A-EL (US)]

SM2335471


id0517n11191x5

Warning
• When performing the initial learning, apply the parking brake securely and block the front and rear wheels using wheel blocks so that the vehicle does not move. Otherwise, the vehicle may move which could lead to an accident because the gears are forcibly changed with the engine running and the shift lever in the drive position while in the initial learning.
Note
• While the initial learning is being performed, the following phenomena may occur.
― Shift shock occurs intermittently.
― Indications such as selector lever positions differ from those displayed normally.
• The automatic transaxle initial learning can be performed using the M-MDS.



Introduction

• If the initial learning is not completed, perform the initial learning if any of the following parts is replaced. Otherwise, engine racing may occur or shift shock may increase.
― Control valve body
― Oil pressure switch
― Clutch (low clutch, high clutch, R-3-5 brake, 2-6 brake, and low and reverse brake)
― Automatic Transaxle



Initial Learning Procedure


Preparation before servicing

1.Verify initial learning implementation necessity for replacement parts.

Replacement part

Initial learning implementation necessity

Control valve body replacement
Necessary
Oil pressure switch replacement
Necessary
Clutches *1
Necessary
Automatic transaxle replacement
Necessary
ON/OFF solenoid replacement
Unnecessary
Coupler component replacement
Unnecessary
*1:Low clutch, high clutch, R-3-5 brake, 2-6 brake, and low and reverse brake

2.Apply the parking brake firmly, and set the wheel blocks for both the front and rear wheels.

3.Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [ET6A-EL (US)].)


Initial learning procedure

1.Connect the M-MDS.

2.Perform the automatic transaxle initial learning.

3.Using the M-MDS, verify that DTC P06B8:00 has not been stored. (See DTC INSPECTION.)

• If DTC P06B8:00 is displayed, switch the ignition off and repeat the procedure from Step 1.
• If any other DTCs are displayed, repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL) (US)].)