DETERMINING SHORT BETWEEN CIRCUITS LOCATION (CAN-BUS No.8) [(US)]
DETERMINING SHORT BETWEEN CIRCUITS LOCATION (CAN-BUS No.8) [(US)]
SM2566474
id1002x1004800
-
Caution
-
• Perform the following malfunction diagnosis only when it is diagnosed with a short to ground by CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(US)].)
System Wiring Diagram
|
Determination Procedure
-
Caution
-
• When disconnecting the connector, verify that there is no looseness, damage, deformation, corrosion, or poor connection of the connector terminals.• When inspecting the connector, touch it with a paper clip or similar thin pin without directly inserting a tester probe into the terminal.• Disconnect the negative battery cable before performing any work that requires handling of connectors.
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
INSPECT BODY CONTROL MODULE (BCM) FOR SHORT BETWEEN CIRCUITS
• Switch the ignition off.
• Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Disconnect the connector 3 which has body control module (BCM) terminals 3U and 3W.
• Connect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Switch the ignition ON (engine off).
• Measure the voltage at body control module (BCM) terminals 3U and 3V (wiring harness side).
• Is the voltage at body control module (BCM) terminals 2L and 2J (wiring harness side) the same?
|
Yes
|
Go to the next step.
|
No
|
Replace the body control module (BCM) because there is a short between circuits in the body control module (BCM).
|
||
2
|
INSPECT TELEMATICS COMMUNICATION UNIT FOR SHORT BETWEEN CIRCUITS
• Switch the ignition off.
• Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)].)
• Disconnect the telematics communication unit connector.
• Inspect for continuity between telematics communication unit terminals 1Q and 1S (wiring harness side).
• Is there continuity?
|
Yes
|
Repair or replace the wiring harness between telematics communication unit and body control module (BCM) because the wiring harness is shorted between circuits.
|
No
|
Replace the telematics communication unit because there is a short between circuits in the telematics communication unit.
|