DTC P05A0:00 [PCM (SKYACTIV-G)]
DTC P05A0:00 [PCM (SKYACTIV-G)]
SM2334478
id0102t4402200
Outline
System malfunction location |
Active air shutter: Opening angle abnormality (sticking) |
||||
---|---|---|---|---|---|
Detection condition
|
• Active air shutter opening angle is certain value or less while intake air temperature is 5 °C {41 °F} or more.
|
||||
Fail-safe
|
• Performs fully open/closed position learning function three times.
|
||||
Possible cause
|
• Foreign matter caught in active air shutter
• Active air shutter malfunction
• PCM malfunction
|
||||
System wiring diagram
|
• Not applicable
|
||||
Connector diagram
|
• Not applicable
|
Diagnostic Procedure
Step |
Inspection |
Results |
Action |
---|---|---|---|
1
|
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snapshot data.
|
—
|
Go to the next step.
|
2
|
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
• Verify related Service Bulletins, on-line repair information, or Service Information availability.
• Is any related Information available?
|
Yes
|
Perform repair or diagnosis according to the available information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
INSPECT FOR OTHER RELATED DTCs
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Are any of the following DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
No
|
Go to the next step.
|
||
4
|
VERIFY IF FOREIGN MATTER IS LODGED
• Verify if the active air shutter has lodged foreign matter.
• Has the active air shutter lodged any foreign matter?
|
Yes
|
Remove the foreign matter and perform the repair completion verification.
|
No
|
Go to the next step.
|
||
5
|
INSPECT ACTIVE AIR SHUTTER FOR MALFUNCTION
• Inspect the applicable part. (See ACTIVE AIR SHUTTER INSPECTION.)
• Is the part normal?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].)
|
No
|
Go to the next step.
|
||
Repair completion verification 2
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|