DTC P2229:00 [PCM (SKYACTIV-G)]
DTC P2229:00 [PCM (SKYACTIV-G)]
SM2334414
id0102t4153300
Outline
System malfunction location |
BARO sensor circuit high input |
||||
---|---|---|---|---|---|
Detection condition
|
• The PCM monitors input voltage from the BARO sensor. If the input voltage is high for 5 s, the PCM determines that the BARO sensor circuit has a malfunction.
|
||||
Fail-safe
|
• Fixes the barometric pressure for the engine control at 101.32 kPa {1.0332 kgf/cm2, 14.695 psi}.
|
||||
Possible cause
|
• BARO sensor (built-into PCM) malfunction
• PCM malfunction
|
||||
System wiring diagram
|
• Not applicable
|
||||
Connector diagram
|
• Not applicable
|
Diagnostic Procedure
Step |
Inspection |
Results |
Action |
---|---|---|---|
1
|
IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA
• Is the DTC P2229:00 on freeze frame data?
|
Yes
|
Go to the next step.
|
No
|
Go to the troubleshooting procedure for DTC on freeze frame data.
|
||
2
|
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snapshot data.
|
—
|
Go to the next step.
|
3
|
VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
• Verify related Service Bulletins, on-line repair information, or Service Information availability.
• Is any related Information available?
|
Yes
|
Perform repair or diagnosis according to the available information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
4
|
INSPECT BARO SENSOR FOR MALFUNCTION
• Inspect the applicable part. (See BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
• Is the part normal?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the malfunctioning location and perform the repair completion verification.
|
||
Repair completion verification 1
|
VERIFY THAT VEHICLE IS REPAIRED
• Install/connect the part removed/disconnected during the troubleshooting procedure.
• Clear the DTC recorded in the memory. (See CLEARING DTC.)
• Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
• Perform the DTC inspection for the PCM. (See DTC INSPECTION.)
• Is the same Pending DTC present?
|
Yes
|
Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
If the CAN communication is normal, perform the diagnosis from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION (US))].) (See PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITHOUT CYLINDER DEACTIVATION (US))].)
|
No
|
Go to the next step.
|
||
Repair completion verification 2
|
VERIFY IF OTHER DTCs DISPLAYED
• Perform the DTC inspection. (See DTC INSPECTION.)
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|