Menu +
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

FRONT SIDE RADAR SENSOR

FRONT SIDE RADAR SENSOR

SM2334333


id151100006100



Purpose

• The front side radar sensor detects a target vehicle in the blind-spot at the front of the vehicle by emitting microwaves from the radar. The following system is controlled based on target information from the front side radar sensor.
― The front cross traffic alert (FCTA) system



Function


Target vehicle detection function

• The front side radar sensor emits microwaves to the following area to detect an object in the blind-spot at the front of the vehicle from the reflected microwaves.
Note
• The detection ability of the front side radar sensor has limitations. In the following cases, the detection ability may be lower and the system may not operate normally.
― The front bumper near the front side radar sensor has become deformed.
― Snow, ice or mud adheres to the front side radar sensor on the front bumper.
― Under bad weather conditions such as rain, snow and fog.
• Under the following conditions, the front side radar sensor cannot detect target objects or it may be difficult to detect them.
― Stationary objects on a road or a road side such as small, two-wheeled vehicles, bicycles, pedestrians, animals, and shopping carts.
― Vehicle shapes which do not reflect radar waves well such as empty trailers with a low vehicle height and sports cars.
• The front side radar sensor calculates the position, direction of vehicle travel, and relative speed of the detected object from the reflected microwaves.
am3zzn00008314


Automatic configuration function

• When the ignition is switched ON (engine off or on) for the first time after the front side radar sensor has been replaced, the front side radar sensor reads the specification information sent via CAN communication from the body control module (BCM) and it performs automatic configuration.


Radar emission angle correction function

• The front side radar sensor corrects deviations in the radar emission angles, caused by installation tolerances after related part replacement, by implementing the radar aiming procedure. For the radar aiming implementation timing and procedure, refer to the [FRONT SIDE/REAR SIDE RADAR SENSOR AIMING] in the workshop manual.



Structure/Construction

• One front side radar sensor each is located on the left and right of the bracket inside the front bumper.
• Weight reduction has been achieved using hard plastic for the cover of the front side radar sensor.
• The front side radar sensor has one integrated transmitter which emits 24 GHz radar and multiple receivers which receive reflected radio waves.

am3zzn00008315



Operation


Object detection

• The front side radar sensor emits 24 GHz radar waves from the transmitter integrated in the module, and receives the reflected radar waves using the multiple built-in receivers. The front side radar sensor calculates the distance between the object and vehicle based on the time required to receive the reflected radar waves that were emitted, and it calculates the angle (horizontal angle) of the object with the vehicle based on the phase difference between the arriving reflected waves received by the multiple receivers.

am3zzn00008316