PISTON INSPECTION
PISTON INSPECTION
SM1665867
id011000502100
-
Caution
-
• If the piston is replaced, replace the piston, piston pin, and the snap ring as a single component.
1.Measure the piston outer diameter using the micrometer.
-
• Except MX-5 (ND) VIN Serial No.300001-: The measurement position is 8.0 mm {0.31 in} from the lower end of the piston (area with no coating on the piston skirt) and in the thrust direction.• MX-5 (ND) VIN Serial No.300001-: The measurement position is 6.5 mm {0.256 in} from the lower end of the piston (area with no coating on the piston skirt) and in the thrust direction.
-
― If it is not within the specification, replace the piston.
-
bpe2ue00000033
|
-
Standard piston outer diameter
-
83.465—83.495 mm {3.2861—3.2872 in}
2.Measure the cylinder bore diameter. (See CYLINDER BLOCK INSPECTION.)
3.Calculate the cylinder-to-piston clearance from the cylinder bore diameter and the piston outer diameter.
-
• If the clearance exceeds the maximum specification, replace the piston or cylinder block.
-
Standard clearance between piston and cylinder
-
0.0250—0.0450 mm {0.00099—0.00177 in}
4.Measure the piston-to-ring groove clearance along the perimeter using a feeler gauge. For the O-ring, measure the clearance with the O-ring assembled to the piston.
-
• If the clearance exceeds the maximum specification, replace the piston or piston ring.
bpe2ue00000034
|
-
Standard clearance between piston ring and ring groove
-
Top: 0.04—0.08 mm {0.002—0.003 in}Second: 0.03—0.07 mm {0.0012—0.0027 in}Oil: 0.04—0.12 mm {0.002—0.004 in}
-
Maximum clearance between piston ring and ring groove
-
Top: 0.12 mm {0.0047 in}Second: 0.10 mm {0.0039 in}Oil: 0.17 mm {0.0067 in}