HOW TO USE THIS MANUAL
HOW TO USE THIS MANUAL
SM2333615
id000000600900
Efficient Replacement of Body Panels
• This section contains information on the body panels in regard to the welding types, number of spot welds, and cut‐and‐join locations that are necessary for panel removal and installation.
• The type of weld and position are indicated by symbols.
• Some sections have notes concerning the operation being performed. Thoroughly read and understand the notes before carrying out any procedures.
Example
acxuub00000031
|
Symbols of Panel Replacement
• The following 6 symbols are used to indicate the type of weld that is used when replacing body panels.
ac5wzb00000204
|
Body Dimensions (Flat‐plane Dimensions)
• Flat‐plane dimensions are the dimensions measured by projecting certain reference points onto a plane surface.
acxuub00000033
|
• When there are no specific indications, the standard points and dimensions are symmetrical in regard to the center of the vehicle.
• The hypothetical lines may differ according to the vehicle model.
• The schematic diagram shows the vehicle as it is projected from the underbody.
Example
ac9uub00000034
|
Body Dimensions (Straight‐line Dimensions)
• Straight‐line dimensions are the actual dimensions between two standard points.
acxuub00000035
|
• When there are no specific indications, the standard points and dimensions are symmetrical in regard to the center of the vehicle.
Example
am3uub00000073
|
Symbols of Body Dimensions
• The following 8 symbols are used to indicate the standard points.
acxuub00000037
|
