Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor from the surge tank.

Installation

• Install the component with the specified torques. • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

• Insert the sensor in the installation hole and be careful not to damage.

1.	Installation is reverse of removal. Manifold absolute pressure sensor installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)