Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector
(DLC). |
| 2. |
Start the engine and measure the output
voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to
“Specification”
|
|
ETC Motor
| 1. |
Turn the ignition switch
OFF. |
| 2. |
Disconnect the ETC module
connector. |
| 3. |
Measure resistance between the ETC module
terminals 1 and 2. |
| 4. |
Check that the resistance is within the
specification.
Specification:
Refer to
“Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Remove the resonator and the air intake
hose.
(Refer to Engine Mechanical System - “Air
Cleaner”) |
| 3. |
Disconnect the ETC module connector
(A).
|
| 4. |
Remove the installation bolts, and then remove
the ETC module (A) from the engine.
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before
installing. | |
| 1. |
Installation is reverse of
removal.
Electronic
throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~
7.2 lb-ft)
|
|
| ETC module learning
procedure |
When installing new ETC
module or re-installing it, ETC module learning procedure must be
performed.
| 1. |
Hold the ignition key or the start button at
th IG ON position during 5 seconds. |
| 2. |
Turn ignition swich OFF and then start the
engine. |
|
DTC codes (P0638, P2110) might be displayed if
ETC module learning procedure does not performed after replacing ETC
module. |
