| 1. |
Turn the ignition switch
OFF. |
| 2. |
Disconnect the OCV
connector. |
| 3. |
Measure resistance between the OCV terminals 1
and 2. |
| 4. |
Check that the resistance is within the
specification.
Specification: Refer to
“Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Disconnect the CVVT oil control valve
connector (A). |
| 3. |
Remove the installation bolt (B), and then
remove the valve from the engine.
[Bank 1 /
Intake]
[Bank 1 /
Exhaust]
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before
installing. | |
| •
|
Apply engine oil to the valve
O-ring.
| |
| 1. |
Installation is reverse of
removal.
CVVT oil
control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~
8.7 lb-ft)
| | |
