| 1. |
Check the signal waveform of the CMPS and CKPS
using the GDS.
Specification:
Refer to “Wave
Form”
|
|
| •
|
DON’T remove the camshaft position
sensor while the engine is running or right after engine is
turned off. The part and engine oil is hot and can cause
burns.
| |
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Disconnect the camshaft position sensor
connector (A). |
| 3. |
Remove the installation bolt (B), and then
remove the sensor.
|
| 1. |
Turn the ignition switch OFF and disconnect
the battery negative (-) cable. |
| 2. |
Disconnect the camshaft position sensor
connector (A). |
| 3. |
Remove the installation bolt (B), and then
remove the sensor.
|
| •
|
Install the component with the specified
torques. |
| •
|
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before
installing. | |
| •
|
Apply the engine oil to the
O-ring. | |
| •
|
Insert the sensor in the installation
hole and be careful not to
damage. | |
| •
|
Be careful not to damage the sensor
housing and the connector. |
| •
|
Be careful not to damage the
O-ring.
| |
| 1. |
Installation is reverse of
removal.
Camshaft
position sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~
8.7 lb-ft)
| | |
