| 1. |
With the washer motor connected to the
reservoir tank, fill the reservoir tank with water.
|
Before filling the reservoir tank with
water, check the filter for foreign material or contamination.
if necessary, clean the
filter. | |
| 2. |
Connect positive (+) battery cables to
terminal 1 and negative (-) battery cables to terminal 2
respectively. |
| 3. |
Check that the motor operates normally and the
washer motor runs and water sprays from the front
nozzles. |
| 4. |
If they are abnormal, replace the washer
motor.
Pin No.
|
Description
|
1
|
Ground
|
2
|
Front
windshield washer (+)
|
3
|
Rear
windshield washer (+)
|
|
| -
|
When servicing the washer pump, be
careful not to damage the washer pump
seal. |
| -
|
Do not operate the washer pump before
filling the washer reservoir.
Failure to do so could result in
premature pump
failure. | |
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the front right tire and the wheel
cover. |
| 3. |
Remove the washer hose and disconnect the
washer motor connector (A).
|
| 4. |
Remove the washer reservoir after removing 2
bolts (A).
|
| 1. |
Install the washer reservoir.
|
Before installing the pump motor, check
the filter for foreign material or contamination. if
necessary, clean the filter into the pump
motor. | |
| 2. |
Install the washer
motor. |
| 3. |
Install the washer
hose. |
| 4. |
Connect the washer motor
connector. |
| 5. |
Install the tire and the wheel
cover. |
| 6. |
Check the washer motor
operation. | |
