2016 – MX-5 – Restraints

CLOCK SPRING INSPECTION [STANDARD DEPLOYMENT CONTROL SYSTEM]

1. Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the following parts:

a. Driver–side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)

b. Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

c. Column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

3. Disconnect the clock spring connector. (See CLOCK SPRING REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)

4. Disconnect the steering angle sensor connector. (with adaptive front lighting system (AFS)) (See STEERING ANGLE SENSOR REMOVAL/INSTALLATION.)

5. Verify that the continuity is as indicated in the table.

• If not as indicated in the table, replace the clock spring. (See CLOCK SPRING REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)

NOTE:

• When the vehicle-side connector for the clock spring is disconnected, terminals 2A and 2B are shorted to prevent unexpected operation (deployment) of the air bag module.

< Previous Next >