Description

Configuration data not received from instrument cluster

Detection condition

• BCM cannot receive the configuration data from the instrument cluster with the ignition switched ON (engine off or on).

Fail-safe

Not applicable

Possible cause

NOTE:

• To correctly write the configuration data sent from the instrument cluster to the BCM to the BCM, 30 s or more need to have elapsed since the ignition was switched ON (engine off or on).

• DTCs are stored in the instrument cluster.

• Instrument cluster configuration not implemented

• Instrument cluster internal memory malfunction

• BCM malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Clear the DTC for the BCM using the M-MDS.

  (See CLEARING DTC [BCM].)

• Switch the ignition ON (engine off or on) and wait for 30 s or more.

• Retrieve the BCM DTCs using the M-MDS.

  (See DTC INSPECTION [BCM].)

• Is the same DTC displayed?

Yes

Go to the next step.

No

Go to Step 5.

2

• Retrieve the instrument cluster DTCs using the M-MDS.

  (See DTC INSPECTION [INSTRUMENT CLUSTER].)

• Are any DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [INSTRUMENT CLUSTER].)

No

Go to the next step.

3

• Using the M-MDS, perform the instrument cluster configuration (using As-Built data).

  (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

• Clear the DTC for the BCM using the M-MDS.

  (See CLEARING DTC [BCM].)

• Switch the ignition ON (engine off or on) and wait for 30 s or more.

• Retrieve the BCM DTCs using the M-MDS.

  (See DTC INSPECTION [BCM].)

• Is the same DTC displayed?

Yes

Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step.

(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

No

Go to Step 5.

4

• Clear the DTC for the BCM using the M-MDS.

  (See CLEARING DTC [BCM].)

• Switch the ignition ON (engine off or on) and wait for 30 s or more.

• Retrieve the BCM DTCs using the M-MDS.

  (See DTC INSPECTION [BCM].)

• Is the same DTC displayed?

Yes

Replace the BCM, then go to the next step.

(See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION.)

No

Go to the next step.

5

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [BCM].)

No

DTC troubleshooting completed.