Description

Instrument cluster configuration not implemented

Detection condition

• The connectivity master unit (CMU) detected any of the following conditions with the ignition switched to ACC or ON (engine off or on).

• Instrument cluster configuration not read

• Configuration data cannot be written to connectivity master unit (CMU) memory.

Fail-safe

Not applicable

Possible cause

NOTE:

• To correctly write the configuration data, which is sent from the instrument cluster to the connectivity master unit (CMU), to the connectivity master unit (CMU), 30 s or more must have elapsed since the ignition was switched ON (engine off or on).

• Instrument cluster configuration is not completed.

• Instrument cluster malfunction

• Connectivity master unit (CMU) malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Clear the DTC for the connectivity master unit (CMU) using the M-MDS.

  (See CLEARING DTC [CONNECTIVITY MASTER UNIT].)

• Switch the ignition ON (engine off or on) and wait for 37 s or more.

• Perform a CMDTC self-test using the M-MDS.

  (See DTC INSPECTION [CONNECTIVITY MASTER UNIT].)

• Are there any modules other than the connectivity master unit (CMU) displaying DTC U2300:55?

Yes

Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step.

(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)

No

Go to Step 3.

2

• Clear the DTC for the connectivity master unit (CMU) using the M-MDS.

  (See CLEARING DTC [CONNECTIVITY MASTER UNIT].)

• Switch the ignition ON (engine off or on) and wait for 37 s or more.

• Perform a CMDTC self-test using the M-MDS.

  (See DTC INSPECTION [CONNECTIVITY MASTER UNIT].)

• Are there any modules other than the connectivity master unit (CMU) displaying DTC U2300:55?

Yes

Replace the instrument cluster, then go to the next step.

(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

No

Go to the next step.

3

• Clear the DTC for the connectivity master unit (CMU) using the M-MDS.

  (See CLEARING DTC [CONNECTIVITY MASTER UNIT].)

• Switch the ignition ON (engine off or on) and wait for 37 s or more.

• Retrieve the connectivity master unit (CMU) DTCs using the M-MDS.

  (See DTC INSPECTION [CONNECTIVITY MASTER UNIT].)

• Is the same DTC displayed?

Yes

Replace the connectivity master unit (CMU), then go to the next step.

(See CONNECTIVITY MASTER UNIT (CMU) REMOVAL/INSTALLATION.)

No

Go to the next step.

4

• Are any other DTCs displayed?

Yes

Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.

(See DTC TABLE [CONNECTIVITY MASTER UNIT].)

No

DTC troubleshooting completed.