Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

CRASH ZONE SENSOR REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM]

< Previous Next >

2016 – MX-5 – Restraints

CRASH ZONE SENSOR REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM]

WARNING:

1. Switch the ignition off.

2. Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

3. Remove the front bumper. (See FRONT BUMPER REMOVAL.)(See FRONT BUMPER INSTALLATION.)

4. Remove the bolt.

5. Remove the cover.

6. Remove the bolt.

7. Disconnect the crash zone sensor connector. (See Crash Zone Sensor Connector Disconnect Note.)

8. Remove the crash zone sensor.

9. Install in the reverse order of removal.

10. Switch the ignition ON (engine off or on).

11. Verify that the air bag/seat belt pre-tensioner system warning light illuminates for approx. 6 s and turns off.

Crash Zone Sensor Connector Disconnect Note

1. Pull out the crash zone sensor connector lock lever in the direction of arrow (1) shown in the figure.

2. While pressing the lock lever in the direction of arrow (2) shown in the figure, disconnect the crash zone sensor connector.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.