Menu +
Generic selectors
Exact matches only
Search in title
Search in content

SIDE AIR BAG SENSOR REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM]

< Previous Next >

2016 – MX-5 – Restraints

SIDE AIR BAG SENSOR REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM]

WARNING:

1. Switch the ignition off.

2. Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

3. Remove the scuff plate. (See SCUFF PLATE REMOVAL/INSTALLATION.)

4. Remove the tire house trim. (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

5. Disconnect the side air bag sensor connector. (See Side Air Bag Sensor Connector Disconnect Note.)

6. Remove the bolt.

7. Remove the side air bag sensor.

8. Install in the reverse order of removal.

9. Switch the ignition ON (engine off or on).

10. Verify that the air bag/seat belt pre-tensioner system warning light illuminates for approx. 6 s and turns off.

Side Air Bag Sensor Connector Disconnect Note

1. Pull out the side air bag sensor connector lock lever in the direction of arrow (1) shown in the figure.

2. While pressing the lock lever in the direction of arrow (2) shown in the figure, disconnect the side air bag sensor connector.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.