Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

PASSENGER COMPARTMENT TEMPERATURE SENSOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]

< Previous Next >

2016 – MX-5 – HVAC

PASSENGER COMPARTMENT TEMPERATURE SENSOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the following parts:

a. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)

b. Shift lever knob (MT)

c. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION.)

d. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

e. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION.)

f. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

g. Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION.)

h. Front console component (See FRONT CONSOLE REMOVAL/INSTALLATION.)

i. Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)

j. Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

k. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

l. Hood release lever (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)

m. Driver-side lower panel (See DRIVER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

n. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION.)

o. Center panel No.1 (See CENTER PANEL No.1 REMOVAL/INSTALLATION.)

p. Climate control unit (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER].)

3. While lifting hook A of the sensor grille using a tape-wrapped flathead screwdriver, pull the passenger compartment temperature sensor in the direction of arrow (1) shown in the figure and detach hook A of the sensor grille from tab A of the passenger compartment temperature sensor.

4. While lifting hook B of the sensor grille using a tape-wrapped flathead screwdriver, pull the passenger compartment temperature sensor in the direction of arrow (2) shown in the figure and detach hook B of the sensor grille from tab B of the passenger compartment temperature sensor.

5. Remove the passenger compartment temperature sensor.

6. Remove the aspirator. (See AIR DIST UNIT DISASSEMBLY/ASSEMBLY.)

7. Install in the reverse order of removal.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.