2016 – MX-5 – Engine

MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO.1 REMOVAL/INSTALLATION [SKYACTIV-G 2.0]

NOTE:

• The IAT sensor No.1 is built into the MAF sensor. When replacing the IAT sensor No.1, replace the MAF sensor/IAT sensor No.1.

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Disconnect the MAF sensor/IAT sensor No.1 connector.

3. Remove the screws.

4. Remove the MAF sensor/IAT sensor No.1.

5. Install in the reverse order of removal.

< Previous Next >