Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

COMMANDER SWITCH REMOVAL/INSTALLATION

< Previous Next >

2016 – MX-5 – Body and Accessories

COMMANDER SWITCH REMOVAL/INSTALLATION

CAUTION:

  • The connectivity master unit (CMU) determines the presence/non-presence of a commander switch and records it based on the communication status when the ignition is switched ON (engine off or on) or to the ACC position for the first time after the negative battery cable is connected.

  • If the negative battery cable is connected while the connectivity master unit (CMU) has recorded the non-presence of the commander switch and thereafter a commander switch is installed, the installed commander switch will not operate.

  • When installing or removing the commander switch, always disconnect the negative battery cable, and after the servicing is completed, switch the ignition to ACC or ON (engine off or on) to allow the connectivity master unit (CMU) to record the presence/non-presence of the commander switch.

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the following parts:

a. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)

b. Shift lever knob (MT)

c. Shift panel compartment (See SHIFT PANEL REMOVAL/INSTALLATION.)

d. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

3. Remove the screws.

4. Remove the commander switch.

5. Install in the reverse order of removal.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.