Menu +
Generic selectors
Exact matches only
Search in title
Search in content

DTC P0711:00 [TCM (SJ6A-EL)]

< Previous Next >

2016 – MX-5 – Transmission/Transaxle

DTC P0711:00 [TCM (SJ6A-EL)]

DTC P0711:00

TFT sensor: Sensor malfunction

DETECTION CONDITION

  • Vehicle condition: While driving in D or R position with engine rotating

  • Status: Detects no change in ATF temperature

  • Period: Confirmed 1 time continuously for 10 min or more

FAIL-SAFE FUNCTION

  • Performs control with the ATF temperature of 80 °C {176 °F}.

  • Inhibits learning control.

POSSIBLE CAUSE

  • TFT sensor malfunction

  • TCM connector or terminal malfunction

  • TCM malfunction

SYSTEM WIRING DIAGRAM

Not applicable

Diagnostic procedure

STEP

INSPECTION

ACTION

1

RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION

NOTE:

  • Recording can be facilitated using the screen capture of the PC function.

  • Record the freeze frame data/snap shot data.

Go to the next step.

2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY

  • Verify related Service Bulletins and/or on-line repair information availability.

  • Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

  • If the vehicle is not repaired, go to the next step.

No

Go to the next step.

3

INSPECT FOR DTC

Yes

Follow the applicable DTC inspection procedure, then go to the next step.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (SJ6A-EL)].)

No

Go to the next step.

4

INSPECT TFT SENSOR

Yes

Go to the next step.

No

Replace the TFT sensor, then go to Step 6.

(See TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [SJ6A-EL].)

5

INSPECT TCM CONNECTOR FOR POOR CONNECTION

  • Switch the ignition off.

  • Disconnect the TCM connector.

  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).

  • Are terminals normal?

Yes

Go to the next step.

No

Repair or replace the connector and/or terminal, then go to the next step.

6

VERIFY SAME DTC IS NOT PRESENT

  • Always reconnect all disconnected connectors.

  • Clear the DTC using the M-MDS.

    (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (SJ6A-EL)].)

  • Perform the following procedure to ensure that the DTC has been resolved:

    • Start the engine.

    • Warm-up the engine to normal operating temperature.

    • Drive the vehicle in D position for 10 min or more.

    • Gradually slow down and stop the vehicle.

    • Switch the ignition off.

    • Start the engine.

    • Drive the vehicle in D position for 10 min or more.

  • Perform the DTC inspection using the M-MDS.

    (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (SJ6A-EL)].)

  • Is the same DTC present?

Yes

Replace the TCM, then go to the next step.

(See TCM REMOVAL/INSTALLATION [SJ6A-EL].)

No

Go to the next step.

7

VERIFY DTC TROUBLESHOOTING COMPLETED

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (SJ6A-EL)].)

No

DTC troubleshooting completed.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.