System malfunction location

• U2100:00: Configuration not set

Detection condition

WARNING:

• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

• SAS control module configuration setting has not been done correctly

Fail-safe function

Not applicable

Possible cause

• SAS control module configuration setting not implemented

• SAS control module malfunction

System wiring diagram

Not applicable

Step

Inspection

Action

1

• Are any other DTCs output?

Yes

Repair the malfunction part according to the applicable DTC troubleshooting.

No

Go to the next step.

2

• Perform the SAS control module configuration using the M-MDS.

  (See SAS CONTROL MODULE CONFIGURATION (USING AS-BUILT DATA) [STANDARD DEPLOYMENT CONTROL SYSTEM].)

• Clear the DTC for the SAS control module using the M-MDS.

  (See CLEARING DTC [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

• Perform the DTC inspection for the SAS control module using the M-MDS.

  (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

• Are the same DTCs present?

Yes

Go to the next step.

No

DTC troubleshooting completed.

3

• Clear the DTC for the SAS control module using the M-MDS.

  (See CLEARING DTC [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

• Perform the DTC inspection for the SAS control module using the M-MDS.

  (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)].)

• Are the same DTCs present?

Yes

Replace the SAS control module.

(See SAS CONTROL MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)

No

DTC troubleshooting completed.