Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

CRUISE CONTROL SWITCH INSPECTION [SKYACTIV-G 2.0]

< Previous Next >

2016 – MX-5 – Engine

CRUISE CONTROL SWITCH INSPECTION [SKYACTIV-G 2.0]

WARNING:

1. Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the driver–side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE REMOVAL [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

3. Disconnect the clock spring connector (part wiring harness-side).

4. Measure the resistance between clock spring terminals 3E and 3A (part wiring harness-side) using a ohmmeter.

Switch condition

Resistance (ohm)

OFF/CANCEL switch held at on

Approx. 0

SET/− switch held at on

Approx. 84.5

RESUME/+ switch held at on

Approx. 189.5

ON switch held at on

Approx. 326.5

Neutral

Approx. 3,311.5

5. Apply battery positive voltage to clock spring terminal 3F (part wiring harness-side), and terminal 3B (part wiring harness-side) to ground.

6. Verify that the LED illuminates.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.