ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [SKYACTIV-G 2.0]
2016 – MX-5 – Engine
ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [SKYACTIV-G 2.0]
Voltage Inspection
NOTE:
-
The APP sensor is built into the accelerator pedal. When replacing the APP sensor, replace the accelerator pedal.
1. Connect the M-MDS to the DLC–2.
2. Switch the ignition ON (engine off).
3. Verify that the APP sensor output voltage (PID: APP1, APP2) increases according to the increase in the accelerator opening angle when the accelerator opening angle is gradually increased. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)].)
-
If verified, go to the next step.
-
If not as verified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
4. Verify that the APP sensor output voltage (PID: APP1, APP2) is within the specification when the accelerator pedal is depressed and not depressed. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)].) (See PCM INSPECTION [SKYACTIV-G 2.0].)
-
If not as specified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
Specification (Reference)
