2016 – MX-5 – Engine

KNOCK SENSOR (KS) REMOVAL/INSTALLATION [SKYACTIV-G 2.0]

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2. Remove the following parts:

a. Seal cover (See SEAL COVER REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

b. Front suspension tower bar (Vehicles with front suspension tower bar) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION.)

c. Intake manifold (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

3. Disconnect the KS connector.

4. Remove the bolt.

5. Remove the KS. (See KS Installation Note.)

6. Install in the reverse order of removal.

KS Installation Note

• Verify that there is no foreign matter caught between the KS unit and cylinder block.

• The direction of the KS connector is within the angle range shown in the figure.

  

< Previous Next >