Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

DTC P061F:00 [PCM (SKYACTIV-G 2.0)]

< Previous Next >

2016 – MX-5 – Engine

DTC P061F:00 [PCM (SKYACTIV-G 2.0)]

DTC P061F:00

Internal control module throttle valve actuator controller performance problem

DETECTION CONDITION

  • When any of the following conditions is met:

    • Start stop unit internal malfunction

    • CAN communication line malfunction between start stop unit and PCM

    • PCM internal malfunction

    Diagnostic support note

  • This is a continuous monitor (other).

  • The check engine light does not illuminate.

  • FREEZE FRAME DATA is not available.

  • Snapshot data is available.

  • DTC is stored in the PCM memory.

FAIL-SAFE FUNCTION

Not applicable

POSSIBLE CAUSE

  • CAN communication line malfunction between start stop unit and PCM

    • Start stop unit terminal 2M—BCM terminal 2D

    • Start stop unit terminal 2O—BCM terminal 2C

    • BCM terminal 3C—PCM terminal 2AK

    • BCM terminal 3D—PCM terminal 2AL

  • Start stop unit connector or terminals malfunction

  • PCM connector or terminals malfunction

  • Start stop unit malfunction

  • PCM malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION

1

RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION

NOTE:

  • Recording can be facilitated using the screen capture function of the PC.

  • Record the snapshot data on the repair order.

Go to the next step.

2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY

  • Verify related Service Bulletins and/or on-line repair information availability.

  • Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

  • If the vehicle is not repaired, go to the next step.

No

Go to the next step.

3

VERIFY RELATED PENDING CODE AND/OR DTC

Yes

Go to the applicable PENDING CODE or DTC inspection.

(See DTC TABLE [PCM (SKYACTIV-G 2.0)].)

No

Go to the next step.

4

INSPECT START STOP UNIT CONNECTOR CONDITION

  • Switch the ignition off.

  • Disconnect the start stop unit connector.

  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).

  • Is there any malfunction?

Yes

Repair or replace the connector and/or terminals, then go to Step 6.

No

Go to the next step.

5

INSPECT PCM CONNECTOR CONDITION

  • Disconnect the PCM connector.

  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).

  • Is there any malfunction?

Yes

Repair or replace the connector and/or terminals, then go to the next step.

No

Go to the next step.

6

VERIFY DTC TROUBLESHOOTING COMPLETED

Yes

Repeat the inspection from Step 1.

Go to the next step.

No

Go to the next step.

7

VERIFY AFTER REPAIR PROCEDURE

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [PCM (SKYACTIV-G 2.0)].)

No

DTC troubleshooting completed.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.