POWER OUTER MIRROR INSPECTION
2016 – MX-5 – Body and Accessories
POWER OUTER MIRROR INSPECTION
Mirror Glass Adjustment
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Door glass (See DOOR GLASS REMOVAL/INSTALLATION.)
d. Door speaker (See DOOR SPEAKER REMOVAL/INSTALLATION.)
e. Glass guide (See DOOR QUARTER GLASS REMOVAL/INSTALLATION.)
3. Apply battery positive voltage and connect the ground to the power outer mirror terminals and inspect the power outer mirror operation.
|
B+ terminal |
Ground terminal |
Operation |
|
C |
F |
Up |
|
F |
C |
Down |
|
I |
F |
Left |
|
F |
I |
Right |
-
If the power outer mirror does not operate as indicated in the table, replace the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)
Heated Outer Mirror Inspection
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Door glass (See DOOR GLASS REMOVAL/INSTALLATION.)
d. Door speaker (See DOOR SPEAKER REMOVAL/INSTALLATION.)
e. Glass guide (See DOOR QUARTER GLASS REMOVAL/INSTALLATION.)
3. Verify that the continuity between heated outer mirror connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)
Blind Spot Monitoring (BSM) Warning Light Inspection
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Door glass (See DOOR GLASS REMOVAL/INSTALLATION.)
d. Door speaker (See DOOR SPEAKER REMOVAL/INSTALLATION.)
e. Glass guide (See DOOR QUARTER GLASS REMOVAL/INSTALLATION.)
3. Verify that the continuity between blind spot monitoring (BSM) warning light connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)
Auto-dimming Outer Mirror Inspection
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Door trim (See DOOR TRIM REMOVAL/INSTALLATION.)
b. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION.)
c. Door glass (See DOOR GLASS REMOVAL/INSTALLATION.)
d. Door speaker (See DOOR SPEAKER REMOVAL/INSTALLATION.)
e. Glass guide (See DOOR QUARTER GLASS REMOVAL/INSTALLATION.)
3. Disconnect the power outer mirror connector.
4. Connect the power outer mirror connector terminal B to a dry cell battery’s plus (+) terminal (1.2 V) and terminal H to its minus terminal.
-
Verify that the mirror side of the outer mirror glass changes color.
5. If there is any malfunction, inspect the outer mirror glass. (See OUTER MIRROR GLASS INSPECTION.)
-
If there is no malfunction in the outer mirror glass, replace the power outer mirror. (See POWER OUTER MIRROR REMOVAL/INSTALLATION.)