Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

AFTER REPAIR PROCEDURE [PCM (SKYACTIV-G 2.0)]

< Previous Next >

2016 – MX-5 – Engine

AFTER REPAIR PROCEDURE [PCM (SKYACTIV-G 2.0)]

1. Switch the ignition off.

2. Connect the M-MDS to the DLC–2.

3. Switch the ignition ON (engine off).

4. Verify the DTC according to the directions on the M-MDS screen.

  • Press the clear button on the DTC screen to clear the DTC.

5. Switch the ignition off for 30 s or more.

CAUTION:

6. Switch the ignition ON (engine on).

7. Verify all accessory loads are off.

8. Start the engine and maintain the engine speed at 2,800—3,200 rpm until the cooling fan starts running (for A/F sensor and HO2S activation).

9. When the cooling fan starts running, idle the engine.

10. Maintain idle for 30 s or more after the cooling fan has stopped (for fuel learning).

11. Perform the DTC inspection again and verify that no DTCs are stored. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)].)

12. Switch the ignition off.

13. Disconnect the M-MDS to the DLC–2.

< Previous Next >

© 2014 Mazda North American Operations, U.S.A.