POWER BRAKE UNIT REMOVAL/INSTALLATION
2016 – MX-5 – Brakes
POWER BRAKE UNIT REMOVAL/INSTALLATION
CAUTION:
-
Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again. Therefore, replace the switch with a new one when replacing the power brake unit or performing any procedure that changes the brake pedal stroke.
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the master cylinder. (See MASTER CYLINDER REMOVAL/INSTALLATION.)
3. Remove the brake pipe from the clip.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. After installation, add brake fluid, bleed the air, and inspect for fluid leakage. (See BRAKE FLUID AIR BLEEDING.)
7. Remove the brake switch. (See BRAKE PEDAL REMOVAL/INSTALLATION.)
8. Inspect the brake pedal. (See BRAKE PEDAL INSPECTION.)
9. Install a new brake switch. (See BRAKE PEDAL REMOVAL/INSTALLATION.)
|
1 |
Power brake unit vacuum sensor connector |
|
2 |
Vacuum hose, clamp |
|
3 |
Snap pin (See Snap Pin Installation Note.) |
|
4 |
Clevis pin |
|
5 |
Nut |
|
6 |
Power brake unit |
|
7 |
Gasket |
Snap Pin Installation Note
1. Install the snap pin as shown in the figure.
