KNOCK SENSOR (KS) REMOVAL/INSTALLATION [SKYACTIV-G 2.0]
2016 – MX-5 – Engine
KNOCK SENSOR (KS) REMOVAL/INSTALLATION [SKYACTIV-G 2.0]
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the following parts:
a. Seal cover (See SEAL COVER REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
b. Front suspension tower bar (Vehicles with front suspension tower bar) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION.)
c. Intake manifold (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
3. Disconnect the KS connector.
4. Remove the bolt.
5. Remove the KS. (See KS Installation Note.)
6. Install in the reverse order of removal.
KS Installation Note
-
Verify that there is no foreign matter caught between the KS unit and cylinder block.
-
The direction of the KS connector is within the angle range shown in the figure.
