< Previous Next >

2016 – MX-5 – Body and Accessories

REAR END PANEL INSTALLATION [PANEL REPLACEMENT]

Symbol Marks

Installation Procedure

1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions.

2. Drill holes for the plug welding before installing the new parts.

3. After temporarily installing new parts, make sure the related parts fit properly.

4. While lowering the rear end panel, place it inside the cabin in the direction of arrow (1) shown in the figure and then move it in the direction of arrow (2).

5. Plug weld the 25 locations indicated by (A) shown in the figure.

6. After repairing the ends of the corner plate, plug weld the 20 locations in area (B) shown in the figure and install the rear end panel.

7. Plug weld the 12 locations indicated by (C) from the room side shown in the figure, then install the rear end panel.

< Previous Next >